Installation Checklist; Checking The Contents; System Components - Cisco 7000 Hardware Installation And Maintenance

Installation Checklist

Use the Installation Checklist in to assist you with your installation and to provide a historical record
of what was done, by whom, and when. Make a copy of this checklist and indicate when each
procedure or verification is completed. When the checklist is completed, place it in your Site Log
(described at the end of this chapter) along with the other records for your new router.

Checking the Contents

Following is the procedure for checking the contents of the shipping container. Use the Installation
Checklist in Table 2-14, the Component List in Table 2-14, and the record of your order to ensure
that you received all the components you ordered.
Step 1
Step 2
Note
pallet. You will need these containers if you need to move or ship the router in the future.
Step 3
Step 4
Step 5
Note
each system. This documentation is available on UniverCD, which can be obtained at no charge
when a router order is placed. For a complete list of documentation, see Ordering Cisco
Documentation in your warranty package.

System Components

Table 2-14 lists all of the standard components that are included with the router and the optional
equipment available. Check each item on the Component List as you unpack and verify it. Insert the
completed checklist into the Site Log, which is described in the following sections.
Verify that one of the accessories boxes contains a power supply. If you ordered a second
power supply it will be shipped separately.
Check the contents of the second accessories box against the Installation Checklist and the
packing slip and verify that you received all listed equipment, which should include the
following:
•
One modular power supply cord for each power supply ordered
•
Router hardware and software documentation, if ordered
•
Serial port adapter cables if your system has serial ports
•
Optional equipment that you ordered, such as network interface cables, transceivers, or
special connectors.
Do not discard the shipping container. Flatten the shipping cartons and store them with the
Check the interface processors in each slot. Ensure that the configuration matches the
packing list and that all of the interfaces are included.
Complete the Port Configuration Worksheet shown in Figure 2-41. Check the interface
processors in the rear of the chassis, and record the interface type for each populated
interface address. You may need to refer to this worksheet during installation.
Proceed to the section "Site Log," then to the chapter "Installing the Router" to begin
installation.
Cisco no longer automatically ships a hard copy of the entire router documentation set with
Installation Checklist
Preparing for Installation 2-111