Jumpers; Leds; Serial Ports; 7000 Series Chassis Interface (Rsp7000Ci) - Cisco 7000 Hardware Installation And Maintenance

Jumpers

There are no user-configurable jumpers on the RSP7000.

LEDs

The two LEDs on the RSP7000 indicate the system and RSP7000 status. The normal LED is on
when the system is operational. During normal operation, the CPU halt LED should be off. The CPU
halt LED goes on only if the system detects a processor hardware failure.

Serial Ports

Two asynchronous serial ports on the RSP7000, the console and auxiliary ports, allow you to connect
external devices to monitor and manage the system. The console port is an Electronic Industries
Association/Telecommunications Industry Association (EIA/TIA)-232 receptacle (female) that
provides a data circuit-terminating equipment (DCE) interface for connecting a console terminal.
Note
standard by the Electronic Industries Association (EIA) and Telecommunications Industry
Association (TIA).
The auxiliary port is an EIA/TIA-232 plug (male) that provides a data terminal equipment (DTE)
interface; the auxiliary port supports flow control and is often used to connect a modem, a channel
service unit (CSU), or other optional equipment for Telnet management.

7000 Series Chassis Interface (RSP7000CI)

The RSP7000CI, shown in Figure 1-10, works with the RSP7000, and consists of a printed circuit
board attached to a metal carrier. The RSP7000CI has no user-configurable jumpers or switches, and
its faceplate contains no LEDs. The RSP7000CI is distinguishable only by the label on its faceplate,
which reads 7000 Series Chassis Interface. (See Figure 1-10.) The RSP7000CI provides the
environmental monitoring and power supply monitoring functions for the Cisco 7000 series chassis.
The RSP7000CI isolates the CPU and system software from chassis-specific variations.
Caution
removal (OIR). Removing an RSP7000 or RSP7000CI while the system is operating might cause the
system to shut down or crash, and might damage or destroy memory files or damage the processor
modules. You must install the RSP7000CI in the 7000 CI slot (slot 6 in the Cisco 7000).
Note
You must also have the RSP7000 installed in the 7000 RSP slot (slot 5 in the Cisco 7000).
The functions of the RSP7000CI are as follows:
•
Report backplane type
•
Report arbiter type
EIA/TIA-232 was known as recommended standard RS-232 before its acceptance as a
The RSP7000 and RSP7000CI processor modules do not support online insertion and
The RSP7000CI requires that your Cisco 7000 is running Cisco IOS Release 10.3(9) or later.
Physical Description
Product Overview 1-35