Advertisement
do not leave the sander running unattended.
8
do not operate the sander when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
When not in use switch sander off, remove plug from power supply and store in safe, dry, childproof area.
9
2. IntroduCtIon
Heavy cast base with adjustable sanding table. Fitted with magnetic no-volt release switch to prevent accidental starting after belt jam. Quiet and
powerful 750W/230V motor. Suitable for metal and fabrication workshops. Floor stand available as an optional extra, model no. SM100/ST.
3. speCIFICatIon
model no .....................................................................Sm100
Power ................................................................ 750W - 230V
Belt speed .............................................................. 19mtr/sec
Flat grinding surface..........................................320 x 105mm
Weight ............................................................................ 28kg
dimensions (W x D x H) ..........................650 x 380 x 260mm
Sanding belt ....................................................100 x 1220mm
80 grit belt .......................................................SM100/B080G
100 grit belt .....................................................SM100/B100G
optional stand ....................................................... SM100/ST
Height with stans ...................................................... 1070mm
Cabinet stand size (W x D x H) ...............380 x 395 x 810mm
4. Contents
4.1.
Unpack carton as illustrated below and identify each part according to item description. Should there be any damaged or missing parts
contact your supplier immediately.
Carton
with item identification
5. assemblY
warnInG! ensure sander has not been connected to mains power supply. Refer to diagrams to assist assembly.
‰
5.1.
tensIon and sandInG stop plate
5.1.1.
The belt tension has been pre-set by the manufacturer. For shipping purposes the manufacturer has slackened the tension by turning
the tension lever to the "Loosen" position. To re-tension the belt push the lever down toward the "tighten" position (fig 1). Install the
sanding stop plate and ensure that it does not touch the sanding belt see fig 1 & 1a.
5.2.
workInG table
5.2.1.
Locate working table in correct position (fig 2) Ensure the distance between the working table and the sanding belt is at 3mm (fig 2a).
5.3.
dust ColleCtor
5.3.1.
Fit the dust collector unit with washer and bolt on each side (fig 3).
5.4.
saFetY FaCe shIeld
5.4.1.
Install the face shield and make adjustments to gain the maximum protection (fig 4 & 5).
fig 1
fig 1a
© Jack Sealey limited
Item 1
main body
Item 5
dust cover
fig 2
fig 2a
Original Language Version
Item 3
Face
Item 2
shield
work table
no description
1
Face shield
2
Support plate
3
Hex bolt 1/4" x 1/2"L
4
Washer M6 x18x2
5
Spring washer 1/4"
6
Wing Nut 1/4"
7
Screw 3/16 x 7/16"L
8
Washer 3/16"x12x0.8
9
Hex nut 3/16"
fig 3
IntroduCtIon
Item 4
sanding stop plate
& tools
Qty
1
no description
1
1
Sanding stop
1
plate
1
2
6mm Hex
1
wrench
1
3
12mm open
2
spanner
2
4
Socket wrench 1
2
fig 4
fig 5
SM100 | Issue:3 (H,F) 13/09/18
Qty
1
1
1
Advertisement
