Page 1
Original 501-23 EN - Assembly Instruction and User Manual (Page 2)
Page 2
TABLE OF CONTENTS 1. Safety and warnings IMPORTANT NOTES! 2. Usage 3. Set up and installation Prior to installment, use and 4. Operation maintenance of the table frame, any installer and any user of the table 5. Maintenance and defects must study this assembly and 6.
Page 3
• the sit and stand table may not be used until it has been assembled and installed according to the instructions. Manufacturer ConSet A/S | Industrivej 23 | 6900 Skjern | Denmark www.conset.com | Tlf.: +45 96800080 | conset@conset.com...
Page 4
7. Parts Lifting column Foot Tabletop support Travers end section Travers middle section Screw M6x12mm Screw M6x12mm Sync box Extender wire Power supply Power cord Control panel Wooden screw 5x16mm Wirenail...
Page 5
8. Assembly Instruction and User Manual Travers assembly Column assembly...
Page 6
Column to travers It is important to tighten all screws to get best possible stability. Wiring See also user manual packed along the Power and Control components.
Need help?
Do you have a question about the 501-23 and is the answer not in the manual?
Questions and answers