CONSET 501-49 Directions For Use Manual

Electric height adjustable desk

Table of Contents

Download this manual

DIRECTIONS FOR USE / ASSEMBLING

WARNING

Prior to installment, use and maintenance of the table frame, any installer and any user of the table must study

this assembly and operation manual carefully, so as to gain a complete understanding of its contents.

ELECTRIC HEIGHT ADJUSTABLE DESK

CONSET – MODEL: 501-49

WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL

ASSEMBLY, SAFETY AND OPERATION INSTRUCTIONS

AND WARNINGS REGARDING THE USE OF THIS

PRODUCT MAY RESULT IN SERIOUS BODILY INJURY.

IMPORTANT NOTES!

334130.0

Table of Contents

Need help?

Do you have a question about the 501-49 and is the answer not in the manual?

Page 1 ELECTRIC HEIGHT ADJUSTABLE DESK CONSET – MODEL: 501-49 DIRECTIONS FOR USE / ASSEMBLING WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL ASSEMBLY, SAFETY AND OPERATION INSTRUCTIONS WARNING AND WARNINGS REGARDING THE USE OF THIS PRODUCT MAY RESULT IN SERIOUS BODILY INJURY.
Page 2 TABLE OF CONTENT 1. SAFETY AND WARNINGS 2. USAGE 3. SET UP AND INSTALLATION 4. OPERATION 5. MAINTENANCE AND DEFECTS 6. TECHNICAL DATA 7. PARTS 8. ASSEMBLY DIRECTIONS 9. DECLARATION OF CONFORMITY SAFETY AND WARNINGS This table complies with the prescribed safety regulations. Inappropriate use may cause damage to persons and table.
Page 3 MAINTENANCE AND DEFECTS ND DEFECTS The table does not require any maintenance by usage as described in chapter 2 in the directions for use. The table does not require any maintenance by usage as described in chapter 2 in the directions for use. The table does not require any maintenance by usage as described in chapter 2 in the directions for use.
Page 4 ASSEMBLY DIRECTIONS e) x 4 continued ….
Page 5 continued ….. c) x 1 a) x 2 b) x 2 continued ….
Page 6 DECLARATION OF CONFORMITY We hereby declare, under our sole responsibility that the following products: ConSet sit and stand table product type 501-49 is in accordance with: Directive 2006/42/EF of The European Parliament and of the Council of 17 May 2006 on machinery and...