Windshield Washer/Wiper Switch (Machines With Operator Cab) - Toro Groundsmaster 360 Service Manual

Windshield Washer/Wiper Switch (Machines with Operator Cab)

Testing the Windshield Washer/Wiper Switch
Groundsmaster 360
16225SL Rev C
g037939
1. Washer/wiper switch
g037938
The windshield washer/wiper switch controls the operation of the windshield
wiper and washer pump. The switch is located in the cab headliner
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, and shut off the engine.
2. To access the switch, remove the roof panel from the top of the cab; refer to
Roof Assembly (page
3. Remove the left or right defrost vent hose from the heat and air conditioning
mixing box to access the flange nuts securing the switch panel and remove
the switch panel from the cab headliner.
4. Disconnect the wire harness electrical connector from the windshield
wiper/washer switch.
5. The windshield wiper/washer switch terminals are identified in
and the circuitry of the switch is shown in the
With the use of a multimeter (ohms setting), test the switch functions to
determine if continuity exists between the various terminals for each switch
position. Check the continuity between the switch terminals.
Figure 214
2. Switch panel
Figure 215
8–10).
Page 5–71 Electrical System: Testing the Electrical Components
(Figure
Figure 215
Circuit Logic Table (page
214).
5–72).