Hilti HIT-HY 170 Instructions For Use Manual page 29

Product Information
– Always keep these instructions together with the product even when given to other persons.
– Material Safety Data Sheet: Review the MSDS before use.
– Check expiration date: See imprint on foil pack manifold (month/year). Do not use expired product.
– Foil pack temperature during usage:
– Base material temperature at time of installation:
Exception in solid clay brick:
– Conditions for transport and storage: Keep in a cool, dry and dark place between +5 °C and 25 °C / 41
°F and 77 °F.
– For any application not covered by this document / beyond values specified, please contact Hilti.
– Partly used foil packs must remain in the cassette and has to be used within 4 weeks. Leave the mixer
attached on the foil pack manifold and store within the cassette under the recommended storage condi-
tions. If reused, attach a new mixer and discard the initial quantity of anchor adhesive.
NOTICE
Improper handling may cause mortar splashes:
– Always wear safety glasses, gloves and protective clothes during installation.
– Never start dispensing without a mixer properly screwed on.
– Attach a new mixer prior to dispensing a new foil pack (ensure snug fit).
– Use only the type of mixer (HIT-RE-M) supplied with the adhesive. Do not modify the mixer in any way.
– Never use damaged foil packs and/or damaged or unclean foil pack holders (cassettes).
Poor load values / potential failure of fastening points due to inadequate borehole cleaning:
– Hilti hollow drill bits TE-CD, TE-YD must be used in conjunction with a properly maintained Hilti vacuum
cleaner with model and suction capacity (volumetric flow rate) as specified in the accessory table.
– The boreholes must be free of debris, dust, water, ice, oil, grease and other contaminants prior to adhesive
injection. Standing water must be removed by flushing with water till clean, brushed 3 strokes with a
wire brush, flushed again till clean, then all water removed (vacuum) and blown for 1 minute with oil-free
compressed air.
– For blowing out the borehole – blow out with oil free air until return air stream is free of noticeable dust.
– For brushing the borehole – only use specified wire brush. The brush must resist insertion into the borehole
– if not the brush is too small and must be replaced.
Borehole filling in solid masonry and concrete:
– Ensure that boreholes are filled from the back of the borehole without forming air voids.
– If necessary use the accessories / extensions to reach the back of the borehole.
– HIT-SC is used in the event of drilling into a cavity in solid masonry bricks.
– For overhead applications use the overhead accessories HIT-SZ and take special care when inserting the
fastening element. Excess adhesive may be forced out of the borehole. Make sure that no mortar drips onto
the installer.
Borehole filling in hollow masonry: Use HIT-SC mesh sleeve. Fill the mesh sleeve with mortar from the cente-
ring cap until mortar escapes at the centering cap (filling control).
Note: Hilti HIT-HY 170 is not tested for use with climbing anchors. Applications of this kind are carried out at the
user's own risk.
Not adhering to these setting instructions can result in failure of fastening points!
Printed: 14.05.2018 | Doc-Nr: PUB / 5213225 / 000 / 05
between +5 °C and 40 °C / 41 °F and 104 °F.
between -5 °C and 40 °C / 23 °F and 104 °F.
between +5 °C and 40 °C / 41 °F and 104 °F.
Hilti HIT-HY 170
en
de
it
fr
cs
sk
hu
lv
et
29