Hilti HIT-HY 170 Instructions For Use Manual page 28

Hilti HIT-HY 170
Universal Adhesive anchoring system for anchor fastenings in concrete and in hollow/solid
masonry made from concrete blocks, clay brick or sand-lime blocks.
Hilti HIT-HY 170
Contains: hydroxypropylmethacrylate(A), dibenzoyl peroxide(B)
(A, B)
Warning
H317
H319
H400
P262
P280
P302+P352
P305+P351+P338
P333+P313
P337+P313
Disposal considerations
Empty packs:
▶ Leave the mixer attached and dispose of via the local Green Dot recovery system
▶ or EAK waste material code: 150102 plastic packaging
Full or partially emptied packs:
▶ Must be disposed of as special waste in accordance with official regulations.
– EAK waste material code: 08 04 09* waste adhesives and sealants containing organic solvents or other
dangerous substances.
– or EAK waste material code: 20 01 27* paint, inks, adhesives and resins containing dangerous
substances.
Content: 330 ml / 11.1 fl.oz.
Hilti accepts no liability for damage or failure caused by:
– Storage and transport not in accordance with the specified conditions.
– Failure to observe the instructions for use and setting data, incorrect use
– Inadequate design of the anchor points, inadequate load bearing capacity of the base material
– Other influences of which Hilti is not aware or on which Hilti has no influence, e.g. use with products from
a third party.
28
Printed: 14.05.2018 | Doc-Nr: PUB / 5213225 / 000 / 05
(B)
May cause an allergic skin reaction. (A,B)
Causes serious eye irritation (A)
Very toxic to aquatic life. (B)
Do not get in eyes, on skin, or on clothing.
Wear protective gloves/protective clothing/eye protection/face protection.
IF ON SKIN: Wash with plenty of soap and water.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact
lenses, if present and easy to do. Continue rinsing.
If skin irritation or rash occurs: Get medical advice/attention.
If eye irritation persists: Get medical advice/attention.
500 ml / 16.9 fl. oz Weight: 540g/19.0oz 820g/28.9oz