Remote Locator - Philips CCZ134AT99 Owner's Manual

CCZ134comb 4/5/99 9:30 PM

28 Remote Locator

Your TV/VCR can find your remote control for you.
When you press the POWER button on the TV/VCR to turn on
the TV/VCR, your remote control beeps and LOCATING
REMOTE appears on-screen. The remote control will beep for
about 30 seconds. Or, press any button on the remote control to
stop the beeping.
If another remote control beeps...
The TV/VCR may find other remote controls. If this occurs, you
can program the TV/VCR to find only its remote control. Follow
the steps below.
1
Press the COMBI button, then press the MENU button.
2
Press the PLAY/
PRIM. SETUP, then press the F.FWD/B button.
3
Press the PLAY/
REMOTE LOCATOR, then press the F.FWD/B button.
PRESS MUTE THEN
PAUSE KEY
TO CHANGE CODE FROM 4
TO END PRESS EXIT
4
Press the MUTE button, then press the PAUSE/STILL
button.
YOUR REMOTE LOCATOR
CODE IS 4
PRESS ANY DIGIT
TO CHANGE CODE
TO END PRESS EXIT
5
Press one Number button (0 - 9) to enter a single-digit code
for your remote control. Your remote control will beep briefly.
YOUR REMOTE LOCATOR
CODE HAS BEEN CHANGED
NEW CODE IS 3
TO END PRESS EXIT
6
Press the STATUS/EXIT button.
Page 28
button or the STOP/ button to select
button or the STOP/ button to select
If another remote control beeps ...
2-3
POWER EJECT
SLEEP SPEED MEMORY
REC/OTR PAUSE/STILL
6
PLAY
REW F.FWD
STOP
1
STATUS/EXIT
1 2 3
CH.
4 5 6
7 8 9
0
A.CH +100
VOL.
CABLE/DBS COMBI
VCR PLUS+
VAR.SLOW /ENTER MUTE
TRACKING F.ADV SLOW
SMART SKIP INDEX
PICTURE SEARCH SEARCH
5
This device complies with part 15
of the FCC Rules. Operation is
subject to the following two condi-
tions: (1) This device may not
cause harmful interference, and (2)
this device must accept any inter-
ference received, including inter-
ference that may cause undesired
operation.
4