Electronic Function - Makita DGA411 Instruction Manual

Electronic function

The tools equipped with electronic function are easy to
operate because of the following feature(s).
Soft start feature
Soft start because of suppressed starting shock.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
► 1 . Hex wrench
Removing or installing circular saw
blade
CAUTION:
Be sure the circular saw blade is
installed with teeth pointing up at the front of the tool.
CAUTION:
Use only the Makita wrench to
install or remove the circular saw blade.
To remove the circular saw blade, press the shaft lock fully
so that the circular saw blade cannot revolve and use the
hex wrench to loosen the hex bolt. Then remove the hex bolt,
ring (country specific), outer flange and circular saw blade.
1
► 1 . Shaft lock 2. Hex wrench 3. Loosen 4. Tighten
2
3
4
For tool without the ring
► 1 . Hex bolt 2. Outer flange 3. Circular saw blade
4. Inner flange
For tool with the ring
► 1 . Hex bolt 2. Outer flange 3. Circular saw blade
4. Ring 5. Inner flange
To install the circular saw blade, follow the removal
procedure in reverse.
12 ENGLISH
1
2
3
4
1
2
3
4
5