Table of Contents
Advertisement
2. Connect the product to a power supply.
See Fig.3
1. Disconnect the product from the power supply when the
battery pack becomes fully charged.
2. Press the battery pack latch to unlock the battery pack
from the product.
3. Slide the battery pack off the product.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the cells in the battery
pack become hot. A hot battery pack should be allowed to
cool down for approximately 30 minutes before attempting
to recharge.
MAINTENANCE
■
When not using or when cleaning the product,
disconnect it from the power supply and remove the
battery pack.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloth or soft brush to remove dirt and dust.
■
Do not, at any time, let brake fluids, gasoline, petroleum-
based products, and penetrating oils come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
■
If you are experiencing any issues with this product
or any other RYOBI product, please contact RYOBI
Customer Service.
WARNING
Hazardous voltages are present within the product; do
not disassemble.
■
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
CLEANING THE CHARGER
WARNING
Unplug the charger power cord from power supply
before cleaning at any time to prevent serious personal
injury.
■
Clean the charger surface (except labels) using a damp
cloth with a mild detergent.
■
Do not use any strong detergents on the plastic housing.
They can be damaged by certain aromatic oils such as
pine and lemon, and by solvents such as kerosene.
■
Moisture can cause a shock hazard. Wipe off any
moisture with a soft dry cloth.
STORAGE
Store your charger in a cool, dry place between 10°C and
38°C.
3
Advertisement
Table of Contents
