Baby Boomer™ Corner Walk-In Bathtub PARTS LIST Use “1 1/2” PVC or ABS Female Adapter (use of PVC or ABS depends on your local or state plumbing codes) Hub x FIPT The ABS or PVC female adapter features a hub x female NPT thread connection and provides a means for adapting a solvent weld connection to a threaded connection.
Baby Boomer™ Corner Walk-In Bathtub TYPICAL FREESTANDING BATHTUB INSTALLATION PROCEDURE Before you start: • Ensure that the floor is even. • The waste-overflow fitting is supplied with the product, however other accessories like the slip joint and adaptors are not included and must be purchased separately.
Baby Boomer™ Corner Walk-In Bathtub INSTALLATION WARNING Electrical appliances (plug, switches, lamps, etc.) must be placed or installed at the minimum safety distance of 2' and a height of 7'-6". Aquaticausa.com Aquaticabath.ca E: info@aquaticabath.com...
Page 5
Baby Boomer™ Corner Walk-In Bathtub INSTALLATION continued Take the tub out of the packaging taking care to hold it from the bottom edge of the tub. Lie it near the place where it will be installed. Remove the panel by unscrewing the three retaining screws at the base and sliding it downwards.
Page 6
Baby Boomer™ Corner Walk-In Bathtub INSTALLATION continued If not already prepared, assembly the drain and distribution column following the instructions in the box. Connect the distribution to the diverter of the taps The bathtub stands on 6 adjustable feet. The leveling must be carefully adjusted for the correct functioning of the tub.
Page 7
Baby Boomer™ Corner Walk-In Bathtub INSTALLATION continued Place the tub in the installation corner and level it perfectly using the feet 1,3,4 and 6. CAUTION To level the tub, act only on the feet and not on the threaded rods. It is important that...
Page 8
Baby Boomer™ Corner Walk-In Bathtub INSTALLATION continued All tubs are individually 100% water tested at the factory in order to ensure their perfect functioning. During this phase of the installation it is necessary to test the product in order to verify that all the adjustments made at the factory have been maintained.
Page 9
Baby Boomer™ Corner Walk-In Bathtub INSTALLATION continued Insert the panel under the tub again, starting from the front side, then under the door and then under the short side. To stop the panel, insert it under the edge of the tub, between the edge itself and the thrust springs. Use the supplied wedges to help you.
Baby Boomer™ Corner Walk-In Bathtub FEATURES 127mm • 18 Gauge Epoxy coated Metal Deck Flange " 121mm • Designed to be installed in an 8” joist space 3-7/8” [ 98mm ] • Can be installed with Waterproofing Membrane (*bronte™ NobleSeal TS Recommended) "...
Baby Boomer™ Corner Walk-In Bathtub INSTALLATION INSTRUCTIONS Attaches to Freestanding Bath W/O A. Cut 5” hole into wood sub-floor (use supplied Cutout Template). B. Measure and cut ABS Tailpiece as necessary to ensure a secure connection to P-Trap below. C. Insert Freestanding Bath Installer™ assembly into floor opening and connect to Pipe below.
Page 12
True Ofuro - Maintenance Instructions True Ofuro - Инструкция по уходу True Ofuro - Installation & Entretien True Ofuro - Manuale per il corretto mantenimento True Ofuro - Instrucciones para la correcta manutención Maintenance Instructions Manuale per il corretto mantenimento ®...
Need help?
Do you have a question about the Baby Boomer and is the answer not in the manual?
Questions and answers