Checking The Gearbox Lubrication; Checking The Nozzle - Toro Pro Force 44549 Operator's Manual

Checking the Gearbox
Lubrication
Service Interval: Every 50 hours
Gearbox capacity: 207 ml (7 fl oz).
1. Position the machine and blower on a level
surface and lower the blower.
2. Remove the 5 bolts and washers securing the
gear case cover to the blower
Figure 15
1. Cover
2. Washer
3. Remove the cover to expose the blower gear
case (Figure 15).
4. Remove the check/fill plug from the side of the
gearbox (Figure
Figure 16
1. Check/fill plug
5. Check the oil level to make sure it is up to the
plug hole in the gearbox. If the lubricant level is
low, add enough SAE 80-90 weight gear lube to
raise the level up to the hole.
6. Install the check/fill plug to the gearbox.
(Figure 15).
3. Screw
4. Gearbox
16).
2. Drain plug
7. Install the cover.

Checking the Nozzle

Service Interval: Before each use or daily
Checking the Nozzle Clamp
1. Check the nozzle clamp
ensure that is tight.
Note:
The nozzle can loosen if it is dragged
over obstacles or through low areas in the
terrain.
2. Tighten the clamp fasteners to maintain a gap
of 1.3 cm (0.50 inch).
The nozzle must rotate freely when moved by
hand.
g022000
1. Nozzle clamp
g022001
14
(Figure 17) daily to
Figure 17
2. 1.3 cm (.50 inch) gap
g023909