Gantner Q Series Manual page 87

Q.series
Gantner Instruments Test & Measurement GmbH
umn, e.g. ff,fff.f [kN] for an output in the unit kN with a total
of seven characters including the decimal point and one post
decimal place.
If negative numbers occur, the display in this example is lim-
ited to -9,999.9 (seven characters without the comma).
7. Click in the Range/Error column to limit the permissible
value range and to define the reaction in the case of an error
(optional).
8. Also optionally, you can specify filtering of the sensor signal
in the Additionals column.
9. Save the changes in a file and close the module once you have
made all the changes:
The file is created within the project folder and the file name
is generated automatically. The project folder bears the same
name as the project. The generated file name contains the
address of the Test Controller through which the module is
connected and an identifier for the relevant module.
IMPORTANT
If the modules are connected through a Test Controller, new
module settings must also be updated there. Select
> Write Project (Update) in the test.commander. The project
file is in this case automatically updated.
Configuration → Setting sensor parameters
5
or File > Save To File And Exit.
or File
87