Troubleshooting; Additional Information - D-Link DBA-1210P Quick Installation Manual

Figure 10: Attaching the Ceiling Brackets
3. Using the included screws, secure the mounting
plate to the ceiling brackets.
Figure 11: Attaching Mounting Plate
4. Connect the Ethernet cable and power adapter
(optional) to the device.
5. Slide the DBA-1210P onto the mounting plate.
Figure 12: Securing the Access Point
Locking the DBA-1210P
If the lock plate was attached, insert a lock through
the device's lock slot to secure the DBA-1210P to the
mounting plate.
Ceiling crossbar
Ceiling bracket
Figure 13: Inserting a Physical Lock
Reboot/Reset the Access Point
If necessary, the DBA-1210P can be manually
rebooted or reset to factory default settings.
Rebooting the device
Press and hold down the reset button between
2 to 5 seconds and release to reboot the device.
Resetting the device
Press and hold down the reset button between
6 to 15 seconds and release to reset the device to
its factory default settings.
Press and hold down the reset button for
more than 15 seconds and release to reset the
device to its factory default settings and force the
device to load an alternate firmware.

Troubleshooting

The DBA-1210P receives its configuration settings
and is managed through the D-Link Nuclias cloud.
If you are experiencing problems connecting
to the D-Link Nuclias cloud, check your Internet
connection. If you still cannot connect to the service,
additional configuration on the device may be
required. Refer to the DBA-1210P User Manual for
detailed information on how to manually configure
the device.

Additional Information

For additional support, please refer to the user
manual, or visit your local D-Link support website.
Warning: This product is to be connected only to
PoE networks without routing to the outside plant.
The equipment power cord must be connected to a
socket-outlet earthling connection.
5