Advertisement
Using Headphones
You can connect a pair of stereo headphones (not included) to the detector, so you
can listen to it privately. Using headphones also saves battery power and makes it
easier to identify subtle changes in the sounds you hear, for better detection results.
To connect headphones to the detector, insert the headphones' 3.5mm plug into the
headphone jack on the control panel.
Note: the detector's built-in speaker disconnects when you connect headphones.
Listening Safety
To protect your hearing, follow these guidelines when you use headphones.
• Set the volume to the lowest setting before you begin listening.
• After you begin listening, adjust the volume to a comfortable level.
• Do not listen at extremely high volume levels. Extended high volume listening can
lead to permanent hearing loss.
• Once you set the volume, do not increase it. Your ears adapt to the volume level
over time, so a volume level that does not cause discomfort might still damage
your hearing.
Traffic Safety
Do not wear headphones while operating your detector near high-traffic areas.
Even though some earphones are designed to let you hear some outside sounds
when listening at normal volume levels, they still can present a traffic hazard.
6
FUNCTIONS AND INDICATORS
A Quick Look At The Detector
Disc / Target LED
Low Batt
Power /
Sensitivity
Headphone Jack
1. ELIMINATOR
- ELIMINATOR— this mode can facilitate you to search for and discriminate the
target type or eliminate the metal target you don't want.
- ALL METAL— it is used to search for all kinds of metal object with ELIMINATOR
set to min. position.
2. SENSITIVITY – it is used as power control and used to adjust the sensitivity.
Rotate the control clockwise away from OFF to power on the detector. Rotate
it fully counter clockwise to power off the detector. As you slowly rotate the
SENSITIVITY clockwise, the sensitivity is gradually increased. In general case,
user can set the SENSITIVITY to a high position. But in mineralized area, or area
with electrical interference, it's better to lower the sensitivity properly.
3. HEADPHONE— insert the stereo headphones' 3.5mm plug into the HEADPHONE
jack. In this case, the internal speaker is disconnected.
4. LED – there are four different color LEDs for four types of metal targets. When
target is found, LED lights for relative target.
- Blue LED: for 25¢ / Silver
- Yellow LED: for 5¢ / Pull Tab / Some Gold Ring
Eliminator
7
Advertisement
