Beko WMP 10744 XA User Manual page 23

4.3.8.2 Functions/Programmes Selected by Pressing the Function Keys for 3 Seconds
• Drum Cleaning+
This programme is selected by pressing the 1st auxiliary function key for 3 seconds.
Run this programme with the machine unloaded on a regular basis (once a month or every two months)
to clean the drum. To obtain better results, put powder lime-scale remover for washing machines into the
detergent compartment no. "2". This programme contains a drying step that runs after the drum cleaning step
to dry the inside of the machine.
C
This is not a washing programme. It is a maintenance programme.
Do not run the programme when there is something in the machine. If you try to do so, the machine detects that there is
load inside and aborts the programme.
• Child lock
Use Child Lock function to prevent children from tampering with the machine. Thus you can avoid any changes
in a running programme.
C
You can switch on and off the machine with On / Off button when the Child Lock is active. When you switch on the machine
again, programme will resume from where it has stopped.
When the Child Lock is enabled, an audio warning will be given if the buttons are pressed. Audio warning will be canceled if
the buttons are pressed five times consecutively.
To activate the Child Lock:
Press and hold Auxiliary Function button 2 for 3 seconds. After the countdown as "CL 3-2-1" on the
display is over, "CL On" symbol appears on the display. Release Auxiliary Function button 2 when this
warning is displayed.
To deactivate the Child Lock:
Press and hold Auxiliary Function button 2 for 3 seconds. After the countdown as "CL 3-2-1" on the
display is over, "CL Off" symbol disappears.
• AntiCrease+
This function is selected when the 4th auxiliary function is pressed and held for 3 seconds and the programme
follow-up light for the relevant step turns on.
When selected, it aerates the laundry for up to 8 hours at the end of the programme to prevent creasing. You
can cancel the programme and take your laundry out at any time during the 8-hour duration. Press the function
selection key or the machine on/off key to cancel the function. The programme follow-up light will remain on
until the function is canceled or the step is complete. If the function cannot be cancelled, it will be active in the
subsequent washing cycles as well.
Opening the loading door in case of power failure:
C
In case of power failure, you can use the loading door emergency handle under the pump filter cap to open the loading
door manually.
A
WARNING:
machine.
Washing Machine / User's Manual
To avoid any water overflow before opening the loading door, make sure there is no water left inside the
23 / EN