Table of Contents
Advertisement
11
DISC SELECT button
Select the desired CD in CDC (CD changer) mode.
12
SC/PS button
Scan tuning. Preset scan tuning. Scan play in CD/CDC
mode.
13
AUD button
Audio control selector; Bass, Treble, Loudness, Balance
& Fader.
14
Dial
Adjusts the volume level/bass/treble/balance/fader.
Storing the station names. Select alfa-numeric charac-
ters.
15
Infrared Sensor (behind acrylic facia)
Permits wireless remote control of AM/FM/CD and CD
changer with optional credit card style remote. See Dealer
for Details.
General Operations
Turning the power On/Off
Press the
to turn on or off the unit.
PWR
Tip
When you turn on the unit, "HELLO" will be displayed then
"WELCOME" will momentarily be displayed before actual
power on.
When you turn off the unit, "SEE YOU" will be displayed then
"GOOD-BYE" will momentarily be displayed before actual
power off.
You can edit these messages. (See "Turn on/off message
edit")
Volume Level Control and Memory
Rotate the dial to adjust the volume.
It is also possible to set the maximum volume for when the
power is switched on by following the procedure explained
below.
1.
Turn the dial until it is set at the required volume.
Volume down
Volume up
2.
Press the
for two or more seconds. The power will
PWR
be switched off and the current volume level recorded.
Muting the sound
Press
.
MUTE / SENS
" MUTE " appears on the display window.
To restore the previous volume level, press
Setting the Clock
The clock uses a 12-hour display system. (factory set)
1.
Turn the ignition key to the ON position.
2.
Press the
PWR
3.
Repeatedly press the
4.
Rotate the dial within 5 seconds to select the 12 or 24-
hour time mode. Each time you rotate the dial, the mode
changes or toggles as follows :
CLOCK 24
CLOCK 12
5.
Repeatedly press the
A. Press the
B. Rotate the dial to set the hour digit.
C. Press the
D. Rotate the dial to set the minute digit.
6.
Press the
DISP
ting mode.
Note
If you make no button input or dial operation in 20 seconds,
the Clock setting mode will turn off automatically.
Ignition-off Clock Recall
again.
The display will illuminate showing the time and then auto-
MUTE / SENS
matically shut off after 5 seconds.
Press the
while the ignition switch is in the " OFF " posi-
DISP
tion.
to turn on the unit.
to display " CLOCK 12 ".
DISP
to display " CLK ADJ ".
DISP
within 5 seconds to flash the hour digit.
MUTE / SENS
to flash the minute digit.
MUTE / SENS
momentarily to complete the Clock set-
E-3
Hide quick links:
Advertisement
Table of Contents
