Advertisement
CONNECTION
The following connections should be made with a computer that has a video output
impedance of 75 ohm.
1.
For one display and one micro computer:
Signal Input
Terminal Board
Feed the video signal from the micro-computer to the
VIDEO IN jack, and slide the 75 OHM TERMINATION
SWITCH to the left. The Audio signal should be connected
to the AUDIO-IN jack.
2.
For two or more displays and one computer:
Signal Input
Terminal Board
Signal Input
Terminal Board
7SOCJIII H
II
Signel Input
Terminal Board
I
--
M,crocompu ttr
Video ,----+-,
Signal
The 75 OHM TERMINATION SWITCH on all the displays
except the last one should be set to the right (HIGH). The
switch on the last display should be set to the left (75
ohm).
METHOD OF CHANGING LINE VOLTAGE
Power supply is 110/120/220/240 volts available. Factory
preset for 240V operation. When using the unit in the area
of 110/120/220 volts, re-adjust the VOLTAGE SELECTOR
TIP as follows:
1.
Remove the back cover.
2.
Disconnect the VOLTAGE SELECTOR TIP from the
PS PWB.
3.
Reconnect the VOLTAGE SELECTOR TIP to the PS
PWB for the local supply voltage.
VOLTAGE SELECTOR TIP
240V
@
220V
@
120V
@
110V
@
PS PWB
Advertisement
