Advertisement
5.
V .HOLD Control
This control allows adjustment of vertical stability. In the event the picture "rolls"
upward or downward, adjust the V .HOLD control clockwise or counterclockwise until the
picture stabilizes.
6.
75-0HM TERMINATION SWITCH
Slide this switch to the left (75 ohm) when the display is connected to equipment that
has a 75 ohm output impedance. Slide the switch to the right (HIGH) when connected to a
higher output impedance.
7.
VIDEO IN and OUT Jacks
The jacks provide "feed through" of a video signal when it is desireable to display the
video signal on more than one monitor. A standard 1.0 volt p-p video signal applied to the
VIDEO IN jack will also appear at the VIDEO OUT jack. The video signal from a computer
should be fed to the VIDEO IN jack via a shielded cable and RCA type phono plug.
8.
AUDIO IN and OUT Jacks
Those jacks provide the same function for audio that the VIDEO IN and OUT jacks
provide for video. An audio signal from a computer should be fed to the AUDIO IN jack
via a shielded cable and RCA type phono plug.
CAUTIONS
1.
To prevent fire or shock hazard, do not expose this monitor to rain or moisture.
2.
Do not install this monitor in an excessively hot location, or in any way obstruct the
ventilation holes on the bottom, sides, or top of the cabinet.
3.
Keep the unit away from high-capacity transformers, motors and other magnet-
equipped apparatus.
4.
If the same characters or graphics are shown for a long time with the BRIGHTNESS
and CONTRAST controls set to maximum positions, part of the screen may be damaged.
Use these controls with care.
l
1
Advertisement
