Table of Contents
Advertisement
Tuning to radio stations
1
Press TUNER on the system or TUN on the
remote control to select TUNER source.
2
Press TUNER on the system or TUN on the
remote control once or more to select desired
waveband: FM or MW (AM).
3
Press TUNING+/- (or
control) to tune to a desired radio frequency.
●
You can also press and hold TUNING+/- (or
5
6
/
on the remote control) for three
seconds to search for a radio station.
➜
SEArCH is displayed.
Note:
– The system is equipped with a built-in MW(AM)
antenna and a fixed FM antenna. For optimal
MW(AM) reception, adjust the position of the main
set until the strongest signal is found. For optimal
FM reception, fully extend and adjust the position
of the FM antenna until the strongest signal is
found.
5
6
/
on the remote
Radio Reception
Programming radio stations
You can store up to 20 radio stations in the
memory manually or automatically (Auto store).
Automatic programming
Press and hold PROGRAM on the remote
control for more than three seconds to activate
programming.
➜
AUTO is displayed and available stations are
programmed in order of waveband.
●
To cancel the programming, press 9.
Manual programming
1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROGRAM to activate programming.
➜
P1 is displayed and PROG flashes on the
display.
3
Press ALBUM/PRESET +/- to allocate a
preset number.
4
Press PROGRAM again to confirm the setting.
5
Repeat the above four steps to store other stations.
●
You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
●
Press ALBUM/PRESET +/- until the desired
preset station is displayed.
15
Advertisement
Table of Contents
Troubleshooting
