PAGE 6
•
All applicable codes and standards need to be followed in the installation of this product.
•
For I/O wiring (discrete), use the following wire type or equivalent: Belden 9918, 18 AWG or
larger.
Adhere to the following safety precautions whenever any type of connection is made to the module.
•
Connect the green safety (earth) ground first before making any other connections.
•
When connecting to electric circuits or pulse-initiating equipment, open their related breakers. Do
not make connections to live power lines.
•
Make connections to the module first; then connect to the circuit to be monitored.
•
Route power wires in a safe manner in accordance with good practice and local codes.
•
Wear proper personal protective equipment including safety glasses and insulated gloves when
making connections to power circuits.
•
Ensure hands, shoes, and floor are dry before making any connection to a power line.
•
Make sure the unit is turned OFF before making connection to terminals. Make sure all circuits
are de-energized before making connections.
•
Before each use, inspect all cables for breaks or cracks in the insulation. Replace immediately if
defective.
8
TECHNICAL SUPPORT
For assistance and manual updates, contact Technical Support at the following locations:
North America:
(317) 916-4274
www.heapg.com
email:
techsppt@heapg.com
Europe:
(+) 353-21-4321-266
www.horner-apg.com
email:
techsupport@hornerirl.ie
No part of this publication may be reproduced without the prior agreement and written permission of Horner APG, Inc.
Information in this document is subject to change without notice.
.
02 AUG 2006
MAN0814-01