Advertisement
MAN0814-01
6
Using RPS and UPS Functions Simultaneously
To use both the RPS and UPS functions simultaneously, follow the steps described in the RPS section
(page 3) and the UPS section (page 4) in this document.
7
SAFETY
When found on the product, the following symbols specify:
Warning: Consult user documentation.
WARNING: To avoid the risk of electric shock or burns, always connect the safety (or earth)
ground before making any other connections.
WARNING: To reduce the risk of fire, electrical shock, or physical injury it is strongly
recommended to fuse the power. Be sure to locate fuses as close to the source as possible.
WARNING: Replace fuse with the same type and rating to provide protection against risk of
fire and shock hazards.
WARNING: In the event of repeated failure, do not replace the fuse again as a repeated failure
indicates a defective condition that will not clear by replacing the fuse.
WARNING: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, or service this
equipment. Read and understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in severe bodily injury or
loss of life.
No part of this publication may be reproduced without the prior agreement and written permission of Horner APG, Inc.
Information in this document is subject to change without notice.
02 AUG 2006
AC/DC Input
Power
Ground
100-240 VAC /
140-340 VDC
Figure 6 – Using RPS and UPS Function
+24 VDC
Load
F1
K
External Battery
Warning: Electrical Shock Hazard.
PAGE 5
Advertisement
