Setting Up The Monitor; Attaching The Stand - Dell UltraSharp 25 Series User Manual

Setting up the monitor

Attaching the stand

NOTE: The stand is not installed at the factory when shipped.
NOTE: The following instructions are applicable only for attaching the
stand that was shipped with your monitor. If you are attaching a stand
that you purchased from any other source, follow the set up
instructions that were included with the stand.
To attach the monitor stand:
1. Follow the instructions on the flaps of carton to remove the stand from the
top cushion that secures it.
2. Remove the stand riser and stand base from the packaging cushion.
3. Insert the stand base blocks fully into the stand slot.
4. Lift the screw handle and turn the screw clockwise.
5. After fully tightening the screw, fold the screw handle flat within the recess.
│
28 Setting up the monitor