Repair Instructions - Signode WP-2 Operation, Parts And Safety Manual

REPAIR INSTRUCTIONS

Refer to pages 10 & 11 of this manual for additional part information and location.
GRIPPER AND WEAR PAD DISASSEMBLY
Remove the following parts:
! ! Front roll pin (38)
! ! Front link (25)
! ! Gripper (24)
! ! Roll pin (15)
! ! Wear pad assembly (37)
Clean, inspect and replace worn and/or broken parts. Clean gripper with wire brush.
NOTE: Gripper can be re-used by rotating it to a new position on the hexagonal gripper shaft.
GRIPPER AND WEAR PAD REASSEMBLY
Clean, inspect and replace worn and/or broken parts before reassembly. Lubricate all moving parts
with Mo-Lith #2 grease, or equivalent, before reassembly. Install the following parts as described:
! ! Wear pad assembly (37)
! ! Roll pin (15)
! ! Gripper (24) - Rotate gripper so that unworn teeth contact the strap.
! ! Front link (25) - Grasp the support pin (29) with pliers at rear link (26) and rotate to align hole.
! ! Front roll pin (38) - Drive in roll pin. Check that pawl handle is spring loaded in both directions.
14 14