TMC Aquarium REEF-Pump 4000 Instructions For Installation And Use Manual page 4

INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
Caution: Do not use any power supply other than the one supplied with your genuine
REEF-Pump. The use of a different power supply will invalidate the guarantee.
- Always isolate the PSU from the mains electricity before installing or carrying out any
maintenance to the pump.
Caution: The REEF-Pump controller is not waterproof and therefore must not be
mounted above the aquarium or sump, or in any position where it may accidentally
fall into water or be splashed by water.
- Only use the correctly-rated controller supplied with the pump, for example the REEF-Pump
4000 controller with the REEF-Pump 4000. A label on the back of the controller denotes
which pump it is designed for. Using the wrong controller with the wrong pump will
invalidate the guarantee.
- Power to the pump must be supplied through a Residual Current Device (RCD) with a rated
residual operating current not exceeding 30mA.
- Never operate the pump without water inside the impeller chamber or with liquids at a
temperature higher than 95F/35°C.
- To ensure the pump continues to maintain a steady water flow, it must be cleaned regularly
to ensure it does not become clogged with debris or detritus.
- Pump rating: 100-240V, 50/60Hz unless marked otherwise.
- Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning, or if it
has been dropped or damaged in any way.
- This unit is designed to be used indoors and is not suitable for any outdoor applications.
- Always leave a drip-loop in the pump cable to prevent water running down the
cable and reaching the controller and power source (see diagram).
- Dispose of this unit responsibly. Check with your local authority for disposal information.
Drip Loop
1