Jebao DC Series Owner's Manual

DC Pump
OWNER'S MANUAL
DCW-2000,DCW-3000,DCW-4000,DCW-5000,DCW-6500,DCW-8000,
DCW-10000
Introduction
The DC pumps are carefully inspected and tested to ensure both safety and operating
performance. However, failure to follow the instructions and warnings in this manual
may result in pump's damage and/or serious injury. Be sure to read and save this
manual for future reference.
Pump Features
● SINE wave technology ,ultra quiet operation.
● High performance with innovational motor, and energy saving up to 65%, super
quiet operation.
● Suitable for both marine and fresh water, Rust free
● IC electronic detection ,automatic power-off protection upon no water.
● Motor protection if rotor is blocked; No copper element.
● With anti-resistant ceramic shaft, longer operation life.
Controller Features
● With 10 mode, adjustable the flow rate and head max.
● "Feed" Model, pause, timing, delay, restart function
● Memory function, ensure that the pump rework upon keeping the same parameter
Operating instructions
1. The pump must be connected with the controller and the 24V adaptor correctly
before work. According to the need to choose different plug and supply cord .
2. Turn on the power, press "-" and "+" button, to adjust the pump flow rate and
Head Max. and the LED instruction light will be on the relative mode
3. Lock / unlock function: press the "+" or "-" button for three seconds until the LED
light flash for two times, the controller locked; Similarly, press the "+" or "-" button for
three seconds again, LED indicator light flashes for two times, the controller unlocked
4. "FEED" function: when the pump is working, press "FEED" button, pump stops
working, the "10min" indicator lights up, the pump reworks automatically at previous
level after 10 minutes. Or you can press the "FEED" button to make the pump rework.
The LED flashing status instruction
No. The controller LED flashing status
working status
1 Over voltage or
under voltage
2 Controller
overheating
3 The impeller stops
running
4 Pump idling
5 Abnormal current of
the controller
6 Lock or unlock Press the "+" or "-" button for
three seconds until LED
indicator flashing for two
times, then the controller will
turn to be locked or unlocked
Performance Parameters Table
No: Model No: Voltage Control box (W)
1 DCW-2000 DC24V DCW-2000
2 DCW-3000 DC24V DCW-3000
3 DCW-4000 DC24V DCW-4000
4 DCW-5000 DC24V DCW-5000
5 DCW-6500 DC24V DCW-6500
6 DCW-8000 DC24V DCW-8000
7 DCW-10000 DC24V DCW-10000
Elimination of
abnormal
phenomena
Check the input
supplying voltage
Check whether the
controller exposed
to the sunshine or
in high temperature
environment
Check whether
something in the
pump or the parts
are wrongly
connected
Check the pump
work dry
Check if the pump
short of voltage or
the controller
broken
The key may be
broken if the light
don't flash
Consumption Flow rate
HeadMax(M)
(W) (L/H)
20 2000 2.5
25 3000 3.0
32 4000 4.0
40 5500 4.0
55 6500 4.5
65 8000 5.5
80 10000 6.0