RCBS 98941 Product Instructions page 8

GO: Press [GO] key to dispense the powder once you have entered a given charge. Or press key
to stop during dispensing. Pressing [GO] again will resume dispensing.
ZERO: Key is used to re-zero the scale. For example, to weigh powder in a powder pan, you
would first place an empty pan on the scale platen and press [ZERO] key to re-zero the scale.
This will automatically subtract the weight of the pan from the scale.
POWDER: There are four default powder dispense speed settings (1-4), refer to table in
Appendix 1 (pg. 16). These will work in either Standard or Match Mode. Switching from
Standard to Match or Match to Standard will automatically switch to the correct default set of
parameters.
To set dispense speed, press the appropriate number key, followed by the [POWDER] key.
Typically Large to Small Extruded powders would be run at the slower dispense speeds while
Ball and Flake type powders would be run at the faster dispense speeds. Keep in mind there
are many different powder types with different kernel weights and shapes which attribute to
differing flow rates. This prevents some powder types from being run at the faster dispense
settings. For example, if you try to run a Large Extruded powder at a Powder Dispense Speed of
4, you will experience an overcharge condition. On the other end of the spectrum, if you run a
Ball type powder at a Powder Dispense Speed of 1, the dispense speed will be extremely long.
The following speeds are available :
1. Powder Dispense Speed 1 (Slowest Dispense Rate)
2. Powder Dispense Speed 2
3. Powder Dispense Speed 3
4. Powder Dispense Speed 4 (Fastest Dispense Rate)
Example: To select a powder dispense speed of 2, press [2] key, followed by [POWDER] key.
TRICKLE : Hold it to manually dispense the powder.
CANCEL: Clear the data or stop the operation.
CAL: Key is used to calibrate the scale. You should calibrate your scale each time you begin a
new reloading session. See the calibration section for full details.
UNITS: Key switches scale from GN (grains) to GM (grams). The default is GN.
MODE: Key is used to view/enter menu settings for dispense mode, match/standard mode,
Bluetooth, powder type and sound (buzzer). To access and change menu settings, the following
keys are used:
1. Depress [MODE] key
2. Use [2] or [8] key to scroll menu items
3. Depress [GO] key to select a menu item
4. Use [4] or [6] key to scroll setting values
5. Depress [GO] key to select the desired value
The table on the next page lists the menu items along with their available setting values with
descriptions. Asterisks denote default setting values (Auto dispense defaults to "on", etc.)
6