Management Ethernet Port - H3C LSWM1FW10 User Manual

Table 2-1 Description of the LEDs provided on the front panel of the OAP card
LED
PWR LED
System status
LED (RUN)
CF card status
LED (CFS)
Management
Ethernet port
status LED
(Management)

Management Ethernet Port

The front panel of an OAP card provides one management Ethernet port, which can work without being
affected by the working status of the switching chip. Typically, a management Ethernet port is used to
connect a PC for loading system programs or debugging, or connect the remote network management
station for implementing remote system management. Table 2-2 describes the management Ethernet
port specifications.
Color Status
Steady green
Steady red
Green/red
Off
Slowly blinking
(1.5 Hz)
Fast blinking (6
Hz)
Green
Off
Steady green
Green
Blinking green
Off
Steady green
Blinking green
Green/Yellow
Steady yellow
Blinking yellow
Off
The power system of the OAP card works
normally.
The power system of the OAP card is faulty.
No power supply to the OAP card.
Note that: If you install an OAP card to a switch
working normally but the PWR LED is off,
check whether the OAP card is well
connected.
The system works normally.
The system is starting up/loading software.
The system works abnormally or the system is
reset.
Note that: When the system is reset, the RUN
LED is off; when the system is starting up, the
RUN LED fast blinks; when the system
completes startup and works normally, the
RUN LED blinks slowly.
The CF card is normal, and no read/write
operation is performed.
The CF card is normal, and a read/write
operation is performed.
No CF card is in the slot.
A 1000 Mbps link is present, but no data is
being received/transmitted.
Data is being received/transmitted at a rate of
1000 Mbps.
A 10/100 Mbps link is present, but no data is
being received/transmitted.
Data is being received/transmitted at a rate of
10/100 Mbps.
No link is present.
2-2
Description