Description Of The Unit; Operation; Handling - Daikin LMSW Series Installation & Operation Manual

3

DESCRIPTION OF THE UNIT

The LMSW series includes air-cooled or water-cooled (optional)units built on the basis of the single-block
principle. They consist of:
4

OPERATION

LMSW single blocks are compression units where cold is produced by vaporizing a liquid refrigerant
(HFC type) at low pressure in a heat exchanger (evaporator). The resulting vapour is brought again into
the liquid state by mechanical compression at a higher pressure, followed by cooling in another heat
exchanger (condenser).
The compressor is hermetic, with reciprocating motion, supplied with single-phase or three-phase power.
5

HANDLING

The unit can be handled by lifting and transport means.
WARNING
Make sure that no one is in transit in the operating area of the lifting/transport
means to prevent any possible accidents to people.
If the unit is in a wooden case or crate, sling the packing properly before
handling it.
Lifting speed shall be such as not to make the packed unit oscillate dangerously
and possibly fall.
3
1. a condensing unit placed outside the cold room;
2. an insulated separation panel
3. an evaporator placed inside the cold room;
4. an electric control panel placed on the condensing unit;
2
1
4