Honda TRUNK NET Installation Instructions

Civic

Download this manual

GENERAL VIEW

FOR YOUR SAFETY (Read carefully)

Introduction of Symbol Messages

• These symbols warn you about the possible hazards and explain how to avoid them. And give you some advices.

DANGER

WARNING

CAUTION

NOTICE

2016

INSTALLATION INSTRUCTIONS

TRUNK NET

You will be killed or seriously hurt if you do not follow the instructions.

You can be killed or seriously hurt if you do not follow the instructions.

You can be hurt if you do not follow the instructions.

Gives advice to prevent damage to the product.

Gives helpful information or instructions to be followed in using the product.

Indicates prohibited actions.

CIVIC

4 ANCHORS

TRUNK NET

08L96-TEA-7000-90

MAR. 2016

1 / 5

Table of Contents

Page 1 You can be hurt if you do not follow the instructions. CAUTION Gives advice to prevent damage to the product. NOTICE Gives helpful information or instructions to be followed in using the product. Indicates prohibited actions. © Honda Access Corp. 2016 08L96-TEA-7000-90 1 / 5...
Page 2: Introduction Of Icons
Introduction of Icons • These icons indicate the working place and the worker’s vision. The place for the vehicle. The place for the instrument panel. • These icons indicate the necessary things for your safety and the work. Wear eye protection. Wear heavy gloves.
Page 3: Parts List
PARTS LIST Trunk Net Kit Trunk net Anchors (4) Screws (4) Turn nuts (4) Nuts (4) TOOLS AND SUPPLIES REQUIRED • Phillips screwdriver • File • Handy remover • Drill • 8 mm Drill bit • Tape • Ruler • Touch-up paint •...
Page 4: Installation
INSTALLATION Enlarge the two clip holes. NOTICE Installing the Trunk Net • Drill the trunk side lining while holding it securely. Remove the two clips. TRUNK SIDE LINING TAPE VEHICLE 8 mm DRILL BIT PANEL 10 mm (0.39 in.) 2 CLIPS <SECTION...
Page 5: Check After Installation
Secure the anchors. Install the trunk net. <SECTION VIEW> ANCHOR TURN NUT 2 LOOPS 2 ANCHORS 4 ANCHORS TRUNK SCREW 2 ANCHORS 2 SCREWS 2 NUTS 2 LOOPS 2 ANCHORS Repeat same procedures for the other side. Check After Installation Check that all parts are installed properly.