Taymor 32-F238 Installation Instructions

document includes template must print at 100%
INSTALLATION INSTRUCTIONS
32-F238 / 32-F238SSS SINGLE SIDED INDICATOR DEADBOLT
For use on doors 1-3/8" to 1-3/4" (35-45 mm) thick
Tools required for new installation:
• Phillips head screwdriver
• 2-1/8" (54 mm) hole saw
• 1" (25.4 mm) drill bit
• Chisel
Tools required for replacement installation:
• Phillips head screw driver
MARK DOOR
1
Measure center line of lock; height as
desired from finished floor. Select 2-3/4"
CENTER LINE
or optional 2-3/8" backset, fold and apply
MARK FOR
template to interior side of door and mark
1" (25.4 mm)
HOLE IN
center of door as indicated on template.
DOOR EDGE
Mark center hole on door face through
guide on template.
MARK FOR 2-1/8"
(54 mm) HOLE
ON DOOR FACE
INSTALL LATCH
3
A. Insert latch in hole, keeping it parallel to face of door. Mark outline of latch face plate and remove latch.
B. Chisel 5/32" (4 mm) deep or until latch plate is flush with door edge.
C. Insert latch and tighten to the door using #8 screws.
DOOR EDGE
FOLD HERE
ON DOOR EDGE
45 mm 40 mm 35 mm
(1-3/4") (1-9/16") (1-3/8")
Make 1" (25.4 mm) hole at center of door edge
TEMPLATE
IMPORTANT
8.5 x 11"
DEADBOLT
THUMB TURN
ASSEMBLY
MOUNTING
SCREWS
DRILL HOLES
2
2-1/8" (54 mm)
HOLE
DOOR SIDE
Ø2-1/8" (54 mm) HOLE
2-3/8" (60 mm) BACKSET
2-3/4" (70 mm) BACKSET
INDICATOR
ASSEMBLY
STRIKE
WOOD FRAME
REINFORCER
DUST BOX
Drill 2-1/8" (54 mm) hole through door face as
marked for lockset. (It is recommended that
holes be drilled from both sides on wood doors
to prevent splitting.) Drill 1" (25.4 mm) hole in
center of door edge for latch.
1" (25.4 mm)
HOLE