FIA POPnetserver 2000 User Manual page 17

S POP
ETTING UP THE NETSERVER
Turning the POPnetserver 2000 On and Off
Turning On the POPnetserver
FIA POPnetserver 2000 User's Guide
2000
Verify the included power cord is connected between the AC receptacle
on the back of the unit and an operational wall outlet or power strip.
NOTE: Make sure the power
supply switch (located on the
rear of the unit near the AC In
plug) is in the "On" position.
This switch should always be
left "On."
Whenever applying or removing power to the POPnetserver, you should
always use the conveniently-located, diamond-shaped power switch on the
front bezel. Using this switch will ensure a proper boot-up and clean
shutdown.
If the unit is off, momentarily pressing the On/Off Switch will initiate the
boot sequence. The blue power indicator LED will flash while the unit is
booting. After the boot process has completed and the unit is ready for
use, this LED will stop flashing and remain on.
17