FIA POPnetserver 2000 User Manual page 15

S POP
ETTING UP THE NETSERVER
Cabling the POPnetserver 2000
Network Cabling
FIA POPnetserver 2000 User's Guide
2000
There are two basic cable options for the POPnetserver. The one you use
depends on whether you're adding the server to a traditional network or to
a single workstation.
Most users will connect the POPnetserver to a hub on an existing network,
as shown in the figure below:
When attaching to a network, connect the included gray Category 5
(CAT5) network cable between the Ethernet connector on the rear of the
unit and a hub on the network.
Connect the included power cord between the receptacle on the back of
the POPnetserver and a grounded, three-pronged outlet or power strip.
15