Advertisement
5.
MAiNTENANcE
.
5.1.
After each use clean the charger clamps, removing corrosive battery fluids.
5.2.
Clean the charger casing and charger leads with a soft cloth and mild detergent solution.
5.3.
Keep the charger leads loosely coiled during storage without snagging or crushing.
DO NOT attempt to repair damaged leads, these must be replaced by your Sealey service agent or a qualified person.
8
DO NOT attempt to repair charger electronics, this must be done by your Sealey service agent or a qualified person.
8
6. TrOUBlESHOOTiNG
cODES
DEScriPTiON
Standby status.
Check battery status before
charging.
Charger is repairing battery.
1) No connection to battery.
2) Short circuit.
3) Reversed polarity connection.
Clip loosened during charging. The
charger stops, an audible alarm will
sound in 25 secs.
Battery voltage too high.
Current leakage inside battery.
Charger internal temperature too
high.
Battery fully charged. Voltage held
until power restored.
WEEE rEGUlATiONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVirONMENT PrOTEcTiON
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. iP32 7Ar
01284 757500
© Jack Sealey Limited
TrOUBlESHOOTiNG
Battery already fully charged.
Temporary indication of start.
Repair mode for sulphated
batteries.
1) Reconnect terminal.
2) Check all connections.
3) Reverse connections.
Check connections and start
charging process again.
Battery voltage not as voltage
setting.
Start charging again, if fault
condition re-occurs, replace battery.
Cooling fan not working. Ambient
temperature too high, (40°C).
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
BSCU25.V2 | Issue:3(4) 23/04/19
Advertisement
