Exiting Setting Mode; Sensors; Automatic Load Sensing; Unbalanced Load Detection System - Bosch WAT28620AU Instruction Manual And Installation Instructions

Sensors

en

Exiting setting mode

To exit and save the settings:
Wait for approx. 15 minutes or
■
Touch œ one last time or
■
Switch off the appliance. The
■
selected settings will take effect the
next time the washing machine is
switched on.
H
Sensors
A utomatic load sensing
S e n s o r s
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Place large and small items of
Note:
laundry evenly in the drum. ~ Page 47
42

VoltCheck

depending on the model
The colon in the ready in // (Ready in) /
/ Finished in display:
Flashes , if the voltage is currently
■
too low.
Pulses, if insufficient voltage was
■
detected during the programme.
Insufficient voltage may lead to
Note:
programme extensions and/or a non-
satisfactory spin result, for example.
2
Cleaning and
maintenance
:
Warning
C l e a n i n g a n d m a i n t e n a n c e
Danger of death!
There is a risk of electric shock if you
touch live components.
Switch off the appliance and pull out the
mains plug.
:
Warning
Risk of poisoning!
Toxic vapours can be produced by
cleaning agents that contain solvents,
e.g. cleaning solvent.
Do not use cleaning agents that contain
solvents.