Operation - Laserworld tarm seven Manual

Manual: tarm Series
Version 2: FB4 version
See chapter 8.2 for operation instructions
DMX out
DMX in
RJ45 for LAN connection to com-
puter with Pangolin Software

8. Operation

8.1. Operation instructions: Version 1 - Browser version
The tarm four and tarm seven lasers can be configured via browser over LAN / WiFi. This is
possible through computer, laptop, but also through mobile phones or tablets, if the control
signal is sent over WiFi via a WiFi capable Router / Access Point. Devices connected to the same
local network as the laser systems are capable to accessing the dedicated laser user interface
through a previously configured IP address or an automatically assigned IP address from a
DHCP server.
If only one single laser shall be configured and the laser system is directly connected to the
control computer by LAN cable, please continue with chapter 8.1.2.1.
8.1.1. DHCP mode - automatic address setting
Requirements: Standard router with DHCP functionality (e.g.: D-Link Wireless AC750 DualBand Easy
Router)
The DHCP mode can be used for the configuration of one or more laser devices
a. Connect the laser device(s) to the router with an ethernet cable (CAT-5 or higher). Make
sure that DHCP mode is activated on the router and that it is capable to provide an auto-
matic IP address ( see the manual of your router ).
page 8 / 53
ILDA in ILDA through
RJ45 for Interlock
Mains connection