Lexus RC 350 2019 Owner's Manual page 376

374 7-2. Steps to take in an emergency
If the tire inflation pressure exceeds the
recommended level, let out some air to
adjust the tire inflation pressure. (P.375,
400)
14 With the compressor switch off, dis-
connect the hose from the valve on
the tire and then pull out the power
plug from the power outlet socket.
Some sealant may leak when the hose is
removed.
15 Install the valve cap onto the valve
of the emergency repaired tire.
16 Attach the air release cap to the
end of the hose.
If the air release cap is not attached, the
sealant may leak and the vehicle may get
dirty.
17 Temporarily store the bottle in the
trunk while it is connected to the
compressor.
18 To spread the liquid sealant evenly
within the tire, immediately drive
safely for about 5 km (3 miles)
below 80 km/h (50 mph).
RC350-RC300_OM_General_OM24884E
19 After driving, stop your vehicle in a
safe place on a hard, flat surface
and reconnect the compressor.
20Turn the compressor switch on and
wait for several seconds, then turn it
off. Check the tire inflation pres-
sure.
If the tire inflation pressure is below
A
2
130 kPa (1.3 kgf/cm
The puncture cannot be repaired.
Contact your Lexus dealer.
If the tire inflation pressure is
B
between 130 kPa (1.3 kgf/cm
bar, 19 psi) and a point below the
recommended level: The tire can
be repaired. Proceed to step 21.
If the tire inflation pressure is at the
C
recommended level: Proceed to
step 22.
or bar, 19 psi):
2
or