Advertisement
PRODUCT OPERATION INTRODUCTION
INSTALLATION METHOD
1. Take the device out of the bubble wrap, including the following three parts; heater,
base and remote control.
Product Operation introduction
2. Put the heater on a flat surface upside-down (with the base facing up). Connect the
base with the heater.
Installation method
1.
3. Turn the unit right way up.
4. Press Power button which is in the back of the device, to turn on.
2.
REMOTE CONTROL OPERATION PANEL
3.
4.
1. Pull out the battery cover on the back of the remote control.
Remote control operation panel
2. Pay attention to the battery polarity, and insert the battery (CR2032) into the tray of
1.
the panel.
2.
3. Push the battery cover back into the remote control.
3.
The function of buttons
THE FUNCTION OF BUTTONS
The fan will operate whenever the heater is heating. If the heater stops working,
The fan will operate whenever the heater is heating. If the heater stops working, then
then the fan will stop working after 10s.
the fan will stop working after 10s.
① After connecting to the power supply and switching on the power, you will hear a
1.
After connecting to the power supply and switching on the power, you will hear a
beeping sound, the heater then enters Standby Mode. The power indicator
② Under standby mode,
lights up.
2.
Under standby mode,
heater, the display panel and fan will then countdown (from 10 to 0 second) before
③ The default setting after
switching off.
3.
The default setting after being switched on is:
a)
Heater: low power,
b)
Oscillation: off,
c)
Timer: 0 hrs,
14064_DHCER20FE Manual_V2.indd 6
Take the device out of the bubble wrap, including the following three parts;
heater, base and remote control.
Put the heater on a flat surface upside-down (with the base facing up). Connect the
base with the heater.
Turn the base right way up.
Press Power switch which is in the back of the device to turn on.
Pull out the battery cover on the back of the remote control.
Pay attention to the battery polarity, and insert the battery (CR2032) into the tray
of the panel.
Push the battery cover back into the remote control.
beeping sound, the heater then enters Standby Mode. The power indicator
heater, the display panel and fan will then countdown (from 10 to 0 second) before
key to turn on/off the heater. When turning off the
switching off.
bein
a)
Heater：low power,
b)
Oscillation：off,
lights off.
c)
Timer：0 hrs,
lights off.
lights up.
d)
Fan：turned on.
e)
Temperature setting: the default temperature setting is 25℃.
lights off.
Fireplace display：turned on, lights up.
lights off.
f)
g)
ECO: turned off,
key to turn on/off the heater. When turning off the
g switched on is:
lights up.
lights off.
ights up.
l
– 6 –
7/12/17 4:25 PM
Advertisement
