Macros - Philips SRU4008/27 Owner's Manual

Macros

The MACRO button, in conjunction with digits 1, 2 and
3, lets you to program and store up to 3 sequences of IR
Commands (button-presses) of your choice. One press
of the respective Macro digit button results in that
sequence of IR commands being sent. Any sequence of
commands that you regularly perform can be reduced to
two button presses (MACRO button followed by digit
1, 2, or 3 button). For example pressing MACRO
followed by a single button can turn on your TV, turn
on your cable box, change to your favorite channel,
turn on your VCR, and tell it to record, etc. A total of 10
button presses can be stored under each of the 3 Macro
digits.
To Setup a Macro
1. Press and hold the SETUP button until the red
indicator turns on. Release SETUP.
2. Press and release the MACRO button. The red
indicator blinks off.
3. Press and release digit button where you want to
store the Macro, i.e. digit 1, 2, or 3 button.
4. Press and Release Mode button for the first device
to be controlled in the Macro sequence. *
5. Press and release the buttons you want to be
included in the Macro, in the order you want them to
be sent (maximum of 9). The red indicator blinks off
with each button press.
6. To store the Macro, press and release the MACRO
button. The red indicator turns off. Note, if you
program the maximum of 9 buttons, the Macro will
be automatically stored on the 9
the red indicator turns off. Macro setup is now
complete.
4.
1.
3.
22
To activate the Macro press and release the MACRO
button followed (within 20 seconds) by the digit 1, 2, or
3 button.
Macro Notes
1. You might want to add "delays" in a Macro
2. There is an automatic delay of half a second
3. * The first button in a Macro sequence MUST be a
To Delete a Macro
1. Press and hold the SETUP button until the red
2. Press and release the MACRO button. The red
3. Press and release digit 1, 2, or 3 button for the
4. Press and hold the SETUP button. The red indicator
button press and
th
1, 4.
2, 6.
3.
Macros, cont.
sequence (e.g. to allow for your TV warm-up time).
Delays can be added by using the PAUSE button
followed by the number of seconds delay required.
For example, to enter a delay of 3 seconds, press and
release PAUSE followed by 3 (in step 4 of "To Setup
a Macro" on the previous page). Maximum delay is
9 seconds. It is not possible to have a "0" digit
entered after Pause i.e. there is no zero delay.
between each IR transmission in a Macro sequence.
Mode button (TV, VCR, etc.).
indicator turns on. Release the SETUP button.
indicator blinks off.
Macro you want to delete.
turns off and the Macro is deleted.
23
2.