Advertisement
ELECTRICAL INSTALLATION
Product
PWRX Power Kit
(
PK00.WRK)
Plug-in AC Powe Kit
(PK00.PAC)
Hard-Wired AC Prower Kit
(
PK00.HAC)
MULTI-AC Power Kit
(
PK00.MAC)
A
PWRX 10-Year Battery Pack
Important: The 7055 series faucets come with the
standard CR-P2 lithium battery installed in the faucet.
No further action required.
PWRK
™
VERSION;
1. Connect PWRX BATTERY PACK (1) to SENSOR
CABLE (2).
2. Secure the connections by installing into CONNECTOR
LOCKING DEVICE (3) as shown. Rotate the END CAPS
(4) to secure the connection within the CONNECTOR
LOCKING DEVICE (3).
3. Determine the mounting location of the PWRX
BATTERY PACK (1) by marking center lines as shown.
4. Place the BRACKET (5) on the horizontal center line
and mark the location of the mounting holes to be
drilled.
5. Using 1/4" diameter drill bit, drill two mounting holes
aproximately 1" deep.
6. Install the two ANCHORS (6) provided into the
mounting holes. Use a hammer to lightly tap the
ANCHORS (7) into place and flush with the finished wall.
7. Place the BRACKET (5) over the ANCHORS (6) and
secure with the SCREWS (7) provided.
Do not overtighten.
8. Insert PWRX BATTERY PACK (1) into BRACKET (5).
Fig. 1
Page
4
5
5
5
BRACKET INSTALLATION
3
2
1
1
HORIZONTAL
C/L
VERTICAL
C/L
4
3
4
3
6
5
7
M965654 Rev. 2.2 (12/17)
Advertisement
