Advertisement
Fig. 1
FINISHED WALL
OR BACKSPLASH
CLEARANCE
25mm (min) - 127mm (max)
(1" min - 5" max)
3/8" COMPRESSION
CONNECTORS
TOOLS REQUIRED; Fig. 2
1 2.5 mm Hex Wrench
(Included)
2 Adjustable Wrench
3 Plumbers' Putty or Caulking
INSTALLATION
SPOUT ASSEMBLY INSTALLATION;
1
Fig. 1
CAUTION
Turn off hot and cold water supplies before beginning
1. Make sure O-RING (1) is installed in spout base. If installing
ESCUTCHEON (2) (optional): Apply a bead of putty to
bottom edge of ESCUTCHEON PUTTY PLATE (2).
IMPORTANT: Do not use putty when installing faucet
without escutcheon.
2. Insert supply HOSES (3), SHANK (4) and SENSOR CABLE
(5) (if equipped) through hole in ESCUTCHEON with PUTTY
PLATE (2) and mounting surface. (Make sure PIN (6) is in back).
3. Assemble RUBBER WASHER (7), BRASS WASHER (8)
and THREADED LOCKNUT (9) onto SHANK (4) from
underside of sink or mounting surface. Hand tighten
LOCKNUT (9).
4. Use a screwdriver to tighten SCREWS (10) on LOCKNUT
(9). Work your way around LOCKNUT (9), tightening the
screws slightly each time until all are snug to ensure
even pressure.
Roughing-in Dimensions
191mm
(7-1/2)
191mm
(7-1/2)
165mm
140mm
(6-1/2)
(5-1/2)
MOUNTING
SURFACE
38mm
(1-1/2 )
457mm
(18)
4 Phillips Screwdriver
5 Tape Measure
Note: All plumbing and electrical wiring must be installed
in accordance with applicable codes, regulations and
standards.
CAUTION: Use only American Standard supplied transformers and
cable sets. Using non-AS supplied cables, or cutting, splicing or
66mm
modifying any components will void the warranty.
( 2-5/8)
28mm (1-1/8)
RECOMENDED CONTROL BOX OR
EQUIVALENT BY OTHERS
4" (102mm) SQ. X 3-1/2" (89mm) DEEP CONTROL BOX
Hubbel-RACO #256 OR EQUAL (BY OTHERS).
HARD-WIRED AND MULTI AC 10' MAX. CABLE LENGTH
Fig. 2
1
3
Fig. 1
1
4
5
3
7
8
9
2
2
4
5
10'
I
MPORTANT: Do not
use putty when installing
faucet without escutcheon.
6
2
(OPTIONAL)
PUTTY
(If required)
MOUNTING
SURFACE
TIGHTEN
SPIN NUTS
I
MPORTANT: Do not
use sealent on threads
10
M965654 Rev. 2.2 (12/17)
Advertisement
