Table of Contents
Advertisement
Volume of the loudspeaker
Adjust the volume of the sound reproduced at the intercom box with the
volume preset (6).
Settings
Four switches - located inside the case, on the circuit board - are used to
configure the circuit according to the system.
The rotary switch designates the box to a particular camera input.
The three small slide switches have the following functions:
Switch
1 BOX
2 TAMPER
3 LAST
Designating the box (CAMERA # switch)
Designating a box to a camera input means that system monitor
associates the box with a certain camera input (the designated input)
although it is physically connected to another. This causes the system
monitor to switch to the camera connected to that input when for
example an alarm is triggered or the doorbell button pressed. This gives
you the opportunity to use the shortest route when wiring a box. The
figure below shows for example a two camera system with three accessory
boxes. The switch CAMERA # is set according to the camera (input) to
which the boxes are designated.
9
Off
On
1
2
OFF
ON
N
Y
Description
box number
tamper-switch override
last accessory box
Advertisement
Table of Contents
