Download Print this page

Sealey SMS2003 Instructions page 2

Saw blade sharpener - bench mounting 110w

Advertisement

warning! Keep away from the grinding wheel when it is turning, and make sure no one is standing close in the line of the grinding
wheel trajectory.
do not allow untrained persons to operate the saw blade sharpener.
8
do not get the machine wet, or use in damp or wet locations or areas where there is condensation.
8
warning! do not use the saw blade sharpener where there are flammable liquids, solids or gases such as paint solvents and
including waste wiping rags etc.
do not operate the saw blade sharpener if any parts are missing or damaged as this may cause failure and/or personal injury
8
do not operate the saw blade sharpener when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
When not in use switch off the saw blade sharpener and remove the plug from the power supply.
9
2. introduction
Suitable for sharpening TCT saw blades in range Ø90-400mm. Fitted with a Ø100mm diamond coated grinding disc for optimising
TCT saw blade performance. Supplied with optional ceramic disc for non TCT blades. Precision 0-25° angle adjustment allowing
each tip to be sharpened exactly the same. Quick and easy to use, whilst also saving money on having to constantly buy new
blades.
3. SPeCIFICATIon
model no ........................................................ SmS2003
motor Power ...............................................110W - 230V
Free Speed ...................................................... 5300rpm
Wheel Diameter ................................................. 100mm
Min. Blade Diameter ............................................. 90mm
Max. Blade Diameter .......................................... 400mm
Angle adjustment................................................. 0 - 25°
diamond Grinding disc ............................... SMS2003.B
Ceramic Grinding disc ................................ SmS2003.C
Weight ...................................................................... 5kg
4. operation
ensure before sharpening saw blades that you wear approved safety goggles, ear defenders, dust mask and safety gloves. All
9
safety instructions in Section 1 must be followed.
warning! ensure the sharpener is bolted to the work surface before use.
warning! Always ensure that the machine is switched off before connecting the plug to the socket and always disconnect before
carrying out any work on the machine.
4.1.
Fit the perspex guard to the front of the disc guard, see fig.9.
4.2.
Fit lever handle, see fig.1.
4.3.
Remove the knob, all washers, the spring and the centring piece from the saw blade holder.
4.4.
Secure the saw blade (which needs to be sharpened), on the bolt and reassemble in the order indicated in fig.2.
4.5.
The saw blade only needs to be centred but not tightly fixed. Screw down the fastening knob only as much as necessary for
sufficient tension, so that the saw blade can still be turned. Make sure that the centring piece is not slanted. (See fig.2).4.4.
4.6.
adJustment of the saw blade
4.6.1.
The position of the saw blade has to be adjusted in accordance to the grinding stone. depending on whether you want to sharpen the tooth
face or the tooth back, the saw blade must be adjusted as shown in the following drawings. The surface which is to be ground must be
parallel to the corresponding side of the grinding stone. (See figs 3 & 4).
© Jack Sealey limited
fig.2
fig.3
Position of the grinding stone
when grinding the tooth face
TCT blade sharpening
note: only sharpen the
front of each saw blade tooth.
diamond coated disc fitted.
fig.4
Original Language Version
fig.1
HSS blade sharpening.
Ceramic disc fitted.
Position of the grinding stone
when grinding the tooth back
SMS2003 | Issue 3 HF 07/03/18

Advertisement

loading