Philips LTC9383/50 Instructions For Use Manual page 11

Figure 24: Installing the Pull Seal
5.10.2 Cradle Assembly
1. Position the housing vertically and replace the cradle
assembly by applying pressure onto the rear cap until
the end of the cradle is securely closed. Make sure
the index marks are aligned with the etch mark on
the housing. See Figure 25.
Etch Marks
(x4 at 90°)
Index Marks
Figure 25: Inserting Cradle Assembly
CAUTION: If a pull seal is installed in the
breather hole, be careful not to pinch the
head of the pull seal. Damage to the pull seal
may allow water to enter the housing causing
damage to the camera and lens.
If the pull seal was installed as described under Pull Seal
Installation, continue with step 2.
If the pull seal was not installed, skip to step 3.
2. Install the front retaining ring so the pull seal is centered
in the retaining ring gap. See Figure 26.
W9608408AE
S925A18DE
W9608409AE
Figure 26: Positioning the Front Retaining Ring
3. Replace the rear retaining ring by inserting it into the
housing groove. This secures the cradle assembly in the
housing. If the housing needs to be tamper resistant, the
TC9380TK (purchased separately) should be installed at
this time.
4. Attach the housing to the appropriate mount or pan/tilt
using instructions provided. According to the
orientation of the housing, the cradle assembly may
need rotating. To rotate the cradle assembly (while
mounted), grasp the fittings and rotate to the desired
position using the index marks as reference. View the
monitor while rotating. See Figure 27.
WARNING: If the cradle is rotated, the front retaining ring
must also be rotated. Position the front retaining ring so the
breather hole is centered in the retaining ring gap.
Figure 27: Rotating Cradle Assembly
CAUTION: If a pull seal is installed in the
breather hole, do not pinch the head of the
pull seal. Damage to the pull seal may allow
water to enter the housing causing damage
to the camera and lens.
11
S925A19EE