6.6
Cover Removal
1. Loosen the top two screws on the rear of the housing. These
screws are captive and will not come out all the way. Do not
remove the bottom two screws. See Figure 1.
Figure 1: Loosening Captive Screws
2. Grasp the housing's front cap and pull forward. Do not
squeeze the cover itself. This will make it difficult to slide off
the cover. See Figure 2.
Figure 2: Removing the Cover
3. The cover is attached to the base. Allow the cover to dangle
from the base.
6.7
Camera/Lens Installation
1. Loosen the two screws holding the camera bracket to the
base. It is not necessary to remove them completely. See
Figure 3.
Figure 3: Removing the Camera Bracket
2. Remove the camera bracket from the base. If you are using
the feed-through feature, refer to section 6.8.3 at this time.
Mounting fixed lens cameras in LTC 9480, LTC 9483
Series, and LTC 9488 Series Housings
3a. Attach the lens to the camera.
3b. Use the 1/4-20 x 3/8-inch screw to mount the camera to the
camera bracket. The lens should extend approximately 6
mm (0.25-in) from the front of the camera bracket. See
Figure 4.
Figure 4: Attaching the Camera
6