Polaris 3500 Manual page 15

28. Drill the mounting holes to the specified location
around the cut out of the socket on the back of din
box. Figure 32.
NOTE: Use 1/4" drill bit.
29. Attach socket (PN 4014228) onto the din box with
two bolts (PN 7518980) and two nuts
(PN 7547427), at specified position.
30. Install the remote with the socket which is attached
to the din box. Figure 33.
31. Connect the negative and positive cable to the
battery which was disconnected in Step 1.
32. Attach the front fascia, center hood, center console,
shift lever housing with cap and finally install the
seat to its position which were disconnected in
Steps 7, 2, 4, 3 and 1 respectively.
P/N 9924528 Rev 03 01/14
Figure 32
Figure 33
-15-
Mounting
hole in
socket
Hole in din box
Bolt