Epson EcoTank M2140 Start Here

M2140
Start Here
IMPORTANT: Before using this product, make sure you read these
instructions and the safety instructions in the online User's Guide.
1
Unpack
Make sure you keep the box shown above for use when
transporting the printer.
Caution: Do not lift the product by gripping the scanner unit. Make
sure you lift using the handholds on the bottom of the product.
Note: Do not open either of the ink bottles until you are ready to fill the
ink tank. The ink bottles are vacuum packed to maintain reliability.
1
Lift up the printer cover until it clicks into place.
2
Remove all protective materials from the product.
Caution: Do not touch the flat white cable, translucent film, or
the ink tubes.
3
Close the printer cover.
Note: Do not turn on the product yet.
2
Fill ink tank and charge
the ink
Warning: Keep the ink bottles out of the reach of children and do not
drink the ink.
Caution: This product requires careful handling of ink. If ink spills,
wipe it off immediately with a damp towel to avoid permanent stains. If
ink gets on your clothes or belongings, it may not come off.
Note:
• Epson cannot guarantee the quality or reliability of third-party ink.
• Use one of the ink bottles included with the printer to set up the
product. Part of the ink will be used to charge the print head. This
bottle may print fewer pages compared with subsequent ink bottles.
1
Open the ink tank cover, then open the cap.
2
Unpack one of the ink bottles. Hold the ink bottle upright
and slowly turn the bottle cap to remove it.
Caution: Do not shake or squeeze the ink bottle. Do not touch
the top of the ink bottle after its cap is removed.
3
Insert the ink bottle into the filling port, as shown below.
Note: Do not force the bottle into position.
4
Wait for the ink to fill the tank. Do not squeeze the bottle.
Note: If ink does not flow from the bottle, lift and reinsert the
bottle.