DeWalt DWE46150 Original Instructions Manual page 24

english
3. Lock the DWV9000 connector (l) to secure.
TRADITIONAL DUST EXTRACTOR VACUUM HOSES
Attach recommended dust extractor vacuum hose
to dust port (a).
OPERATION
WARNING: To reduce the risk
of injury, ALWAYS turn off tool
and disconnect the tool from
the power source before making
any adjustments or removing
or installing attachments or
accessories. This applies to both
the grinder and the dust extractor
vacuum. Such preventative safety
measures reduce the risk of starting the
tool accidentally.
WARNING: For your own safety, read
the instruction manual for both the
grinding tool and the dust extractor
vacuum before using any accessory.
Failure to heed these warnings may
result in personal injury and serious
damage to the tool and the accessory.
When servicing this tool, use only
identical replacement parts.
NOTE: The amount of dust retained by the dust
extractor vacuum is dependent on its filter system.
Refer to the dust extractor vacuum instruction
manual for more information.
1. Ensure all assembly instructions have been
completed.
2. Turn the dust extractor vacuum on as instructed
in the dust extractor vacuum instruction manual.
3. Turn the tool on as instructed in the tool
instruction manual and allow it to reach full
speed before making contact with work surface.
4. Place the surface grinding shroud to flat work
surface such as a floor or wall and begin
grinding.
5. When surface grinding is complete, turn the
tool off and disconnect from the power source.
Allow the tool to stop rotating before laying it
down.
NOTE: The surface grinding shroud and dust
extractor vacuum will only be effective when used
with a diamond surface cup wheel on a flat surface.
22
Installation of the Bail Handle
Assembly
NOTE: The bail handle is included in the
DWE4217KT kit but is not included with the stand-
alone DWE46150 shroud.
1. Lightly pull thumbscrews outwards from handle
so that their threaded ends are pulled inside
handle.
2. Place the handle assembly over the grinder
gear case aligning the thumbscrews with the
threaded holes and the ears on the gear case
with the slots in the bail handle assembly.
3. Tighten the thumbscrews to secure the handle
to the grinder.
ADJUSTMENT OF THE BAIL HANDLE ANGLE:
1. Loosen both thumbscrews 2 full turns.
2. Rotate the handle to the desired 45˚ or 90˚
position making sure that the detent groves
align.
3. Re-tighten the thumbscrews to secure the
handle to the grinder.
Edging Use Application (fig. 1)
This concrete grinding shroud has a door feature to
allow flush grinding against a wall.
1. Turn the tool off and disconnect it from the
power source.
2. Using the edging door tab (f), rotate the edging
door until it snaps into the open postion.
3. Connect the tool to the power source.
4. Position hands and body away from wheel and
door opening.
5. Place the door edge flush to work surface, turn
the tool on and begin grinding. Remove the tool
from work surface before turning the tool off.
6. When flush grinding is complete, turn off the
tool and disconnect from power source. Allow
the tool to stop rotating before laying it down.
7. Using the edging door tab (f), rotate door until it
snaps into the closed position.
MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.