DeWalt DWE46150 Original Instructions Manual page 23

DO NOT use under wet conditions or in presence of
flammable liquids or gases.
The surface grinding shroud is a professional tool.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• Young children and the infirm. This appliance
is not intended for use by young children or
infirm persons without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, ALWAYS turn off the tool
and disconnect the tool from
the power source before making
any adjustments or removing
or installing attachments or
accessories. This applies to both
the grinder and the dust extractor
vacuum. Such preventative safety
measures reduce the risk of starting the
tool accidentally.
Mounting and Removing Surface
Grinding Shroud (fig. 2)
1. Follow the mounting and removing guard
instructions in tool manual to remove the guard
from grinder.
2. Open the clamp lever (g) on the surface grinding
shroud and align the tabs (h) on the surface
grinding shroud with the slots (i) on the grinder
gear case.
3. With the clamp lever open, rotate the shroud
into the desired working position. The surface
grinding shroud should be positioned between
the spindle and the operator to provide
operator protection.
4. Close the clamp lever to secure the surface
grinding shroud on the gear case. Tighten the
clamp adjusting screw (b) to ensure shroud is
secured to gear case.
For optimal positioning, the diamond wheel
should ride above the brushes 3 mm. If
diamond wheel rides inside the shroud or
stands taller than 6 mm the shroud will not work
properly.
NOTICE: Do not tighten the clamp
adjusting screw (b) with the clamp lever
in open position. Undetectable damage
to the surface grinding shroud or the
mounting hub may result.
NOTICE: If surface grinding shroud
cannot be tightened by clamp adjusting
screw, do not use tool and take the tool
and surface grinding shroud to a service
center to repair or replace the surface
grinding shroud.
5. To remove the surface grinding shroud, open
the clamp lever, rotate the surface grinding
shroud to align the slots and tabs and pull up
on the surface grinding shroud.
Mounting Dry Diamond
Surface Cup Wheels (fig. 3)
Follow the mounting and using cutting wheels
instructions in the tool manual and mount the
grinding wheel. DO NOT use Type 1 cutting wheels
or bonded abrasive wheels.
A 125 mm (5 inch) dry diamond surface cup (j)
wheel is recommended for use with this shroud. The
inner flange washer (k) should be installed behind
the wheel allowing free tool removal and proper fit.
Dust Extraction (fig. 1, 4)
WARNING: Use only power tools
recommended by D
attachment.
For more information about D
compatible with this attachment, please contact one
of the authorized services centers listed on the back
cover or refer to the full details of our after-sales
service available on the Internet at: www.2helpU.
com.
WARNING: This attachment MUST
BE used with a dust extractor system.
ALWAYS wear certified safety face or
dust mask.
NOTE: Ensure hose connection is secure.
NOTE: The amount of dust retained by the dust
extractor vacuum is dependent on its filter system.
Refer to the dust extractor vacuum instruction
manual for more information.
All D WALT dust collection shrouds are designed to
e
work with the D WALT Airlock DWV9000 connector.
e
1. Attach the DWV9000 connector (l) to your dust
collector hose (m).
2. Unlock the DWV9000 connector (l) and slide
onto dust port (a).
english
WALT with this
e
WALT power tools
e
21